Home    Company Information    Contact Us

Corporate Information

Continuous Emission
    Monitoring Systems
    In situ



    Standard Extractive
    Dilution Extractive

Flow Monitors

    UltraFlow 150

    DeltaFlow® 180

Gas Monitors


Opacity Monitors


Particulate Monitors


    LaserHawk® 360P




Useful Information
Trade Shows
Quality Policy


Customer Service

Opacity Attenuator (Filter)

Call Center

    Hardware Training
    Software Training

Product Status


Firmware Downloads

Sample Specifications

Contact Us
Visiting Our Facility

Representatives and

Where to Stay

Career Opportunities

Terms and Conditions

Teledyne Monitor Labs is a leading supplier of environmental monitoring
instrumentation, systems and software

The SM®8200 In Situ SO2, NO Analyzer                      NEW!

Teledyne Monitor Labs SM®8200 offers advanced technology for outstanding performance and reliability as an CEM or process gas analysis monitor.


Transceiver and Probe

The transceiver houses the light source, spectrometer, multi-gas photodiode array detector system and various focusing optics for outstanding performance over a significant range of operating conditions.  The transceiver is constructed of a rugged cast aluminum housing which is latch-detachable from the probe assembly for easy removal and service.  A photodiode array is able to specifically measure the absorption at the wavelengths of interest.  Advanced detection and mathematical processing improves gas concentration readings. Calibrations can be conducted using an internal electro-optic calibration cell or external EPA protocol 1 calibration gas.  Calibration gases can be injected into the measurement cell at the stack temperature and pressure. A local user display on the transceiver serves as a simple yet powerful man-machine interface for accessing parameters, measured values and initiating calibration checks.

 The probe assembly is available in various lengths and a variety of different materials.  The Instrument comes in various ranges thereby adding flexibility to a wide variety of applications.   An RTD and pressure sensor is included to make correcting to standard conditions simple and accurate.  A dynamic calibration port is located on the probe flange to enable protocol gases to be flooded into the measurement cavity.

An Analyzer Electronic Box houses the pneumatic controls for calibration gases and electronic controls for transceiver support. 

Multiple options are available to support the SM®8200 including addition Multi I/O Module, Cal Gas Heater Assembly, Plant I/O Module and a Calibration Gas Audit Box for cylinder gas audits.

  • Meets All 40CFR60 and 40CFR75 CEM Regulations For SO2, and NOx CEM Measurements
  • State-of-the-Art UV Source and Solid-State Detector System
  • Fast response
  • Easy installation
  • No Sample Line required
  • Typically No Shelter required
  • Low Cost of Ownership

» SM®8200 Brochure

»  SM®8200 Manual

» SM®8200 Setup sheet

» Ethernet Module Operations Manual

Home | Warranty | Terms of Use | Service & Support | Products | Contact Us

Copyright © 2016 Teledyne Technologies Incorporated. All rights reserved.
35 Inverness Drive East - Englewood, CO 80112